2004 Chevrolet Silverado Changing The Drivers Side Blend Door Actuator

It was still blowing hot out of the driver s side.

2004 chevrolet silverado changing the drivers side blend door actuator.

I removed the new one and tried seeing if the actuator would move when adjusting temp. Remove the 7mm screw from the driver s side of the cross over bracket. In this video we show how to replace the blend door actuator that controls the heat and cold in a 1999 2007 chevrolet silverado. These clips can be brittle and break so be gentle.

I also remove the two 10 mm bolts on the driver s side bracket to make sure the dash will move around freely. Remove the 7 mm screws on the driver s side bracket. I successfully removed the old and installed the new. My a c was stuck on just hot but this.

Begin by using a small screwdriver to release the wiring safety clip on the harness for the actuator. It seems like the actuator is being told to turn the shaft to heat. Inspect the connector for rust or corrosion and clean as needed. Now the u shaped bracket on the passenger side can be removed.

Once released gently pull down on the wiring connector and remove it from the blend door actuator.